Ref:
http://community.brocade.com/thread/5072?start=0&tstart=0
cdp run
fdp run
To enable a Brocade device to globally send FDP packets, enter the following command at the
global CONFIG level of the CLI.
FastIron(config)# fdp run
Enabling FDP at the interface level
You can enable FDP at the interface level by entering commands such as the following.
FastIron(config)# int e 2/1
FastIron(config-if-2/1)# fdp enable
To enable the device to intercept and display CDP packets, enter the following command at the global CONFIG level of the CLI.FastIron(config)# cdp runEnabling interception of CDP packets on an interfaceYou can disable and enable CDP at the interface level. You can enter commands such as the following.FastIron(config)# int e 2/1
FastIron(config-if-2/1)# cdp enable
Syntax: show fdp neighbors [detail | ethernet [<slotnum>/]<portnum>]
To display CDP entries for all neighbors, enter the following command.FastIron# show fdp neighbors
Displaying CDP entries
Displaying neighbors
Enabling interception of CDP packets globallyFastIron(config-if-2/1)# cdp enable
Syntax: show fdp neighbors [detail | ethernet [<slotnum>/]<portnum>]
To display CDP entries for all neighbors, enter the following command.FastIron# show fdp neighbors
Displaying CDP entries
Displaying neighbors
**********************************************************
lldp is not avail
**********************************************************
Configure LLDP values.
Enable LLDP on the switch ports.
Start LLDP.
Write the running configuration to the startup configuration.
Control_Room # config t
Control_Room (config)# lldp enable ports all (default configure ;不需執行)
Control_Room (config)# lldp run
Control_Room (config)# wr mem
no lldp run
no lldp enable ports all
Control_Room#show lldp
Control_Room(config)#show lldp neighbors
Control_Room(config)#show lldp neighbors detail ports ethernet 1/1
Enabling FDP globally
****************************************************************
CISCO CDP
ref: http://www.netadmin.com.tw/article_content.aspx?sn=1412100003&jump=2
show cdp neighbors這個指令而言，可以取得以下這些資訊：
1. 鄰近設備的Device ID
2. 本地端的介面
3. Hold-time值，單位是秒
4. 鄰近設備的種類代碼
5. 鄰近設備的硬體平台
6. 鄰近設備的遠端埠ID
表1 鄰近設備的種類代碼及其代表意義
****************************************************************
CISCO CDP
ref: http://www.netadmin.com.tw/article_content.aspx?sn=1412100003&jump=2
2014/12/24
自動協尋附近所有設備 相互交換資訊以供管理維運
管理大型網路利器 Cisco設備專屬CDP協定
胡凱智
show cdp neighbors這個指令而言，可以取得以下這些資訊：
1. 鄰近設備的Device ID
2. 本地端的介面
3. Hold-time值，單位是秒
4. 鄰近設備的種類代碼
5. 鄰近設備的硬體平台
6. 鄰近設備的遠端埠ID
表1 鄰近設備的種類代碼及其代表意義
 |
沒有留言:
張貼留言